How To Set Up Skateboard Trucks
How To Set Up Skateboard Trucks. Grab a skate tool or 9/16″ socket. We introduce the screws in the holes and install the trucks.
Adding the wheels to the truck. Risers are small pieces of plastic or metal that go between the skateboard. There are a few different ways to set up skateboard trucks, but the most common way is to use risers.
We Introduce The Screws In The Holes And Install The Trucks.
You can flip your skateboard to see if the bolts are perfectly sticking through the grip. Learn how to adjust your skateboard setup, tighten trucks, loosen wheels or vice versa. Press the tape so that it lays flat along the entire deck, and then trim off excess tape using the razor.
If You Don’t Have A Special Skateboard Tool Yet, Your Home Hardware.
Put the bearings to the wheels. Adding the wheels to the truck. This tends to be the trickiest part of the job.
The First Step To Setting Up A Fresh Skateboard Is Mounting The Trucks.
The hardware needed for the wheels are bearings, washers, and nuts. Take four bolts and start inserting them in a grip tape. Make sure to have a skate tool or hex wrench available.
To Join Your Trucks’ Parts, You.
Now turn the board upside down. If you have a brand new deck, you will need to poke through the screw holes to pop out. There are a few different ways to set up skateboard trucks, but the most common way is to use risers.
It Involves The Use Of The Same Spacing, Within The Axis Of The Width.
To tighten your skateboard trucks, follow these steps: Try setting up a slalom course, and try and carve around the markers. Place the skate tool or hex.
Post a Comment for "How To Set Up Skateboard Trucks"